Features
•The Jump-N-Carryprovides plenty of power for starting vehicles – more than enough to start most cars.
•The Jump-N-Carrywill power most 12 Vdc accessories equipped with a male 12 Volt plug. The DC outlet features automatic overload protection.
•The unit features a test switch and battery status gauge, which provides an approximate indicator of the battery’s state of charge.
•The Jump-N-Carryfeatures convenient side-mounted holsters with cable tracks for easy cable and clamp management. Always re-wrap cables and re-holster the clamps, reinstalling the Grip Guards™ in the process, after each use.
•The Jump-N-Carrycontains the latest technology with its 12 Volt sealed, non-spillable battery and may be stored in any position.
Battery Status Gauge
Press and hold the red test button to display the battery status on the gauge.
•The Green shaded area indicates the unit is capable of jump starting.
•The Yellow shaded area indicates the unit needs to be recharged.
•The Red shaded area indicates the unit must be recharged immediately.
You can also get a quick check of the vehicle’s charging system by depressing the red test button while connected to a running vehicle and observing the gauge.
Recharging
Note: Upon initial purchase, your Jump-N-Carryshould be charged for a minimum of 24 hours.
There are two ways to charge your Jump-N-Carry. The recommended method is recharging using AC power, with an extension cord (see note below) connected to the built-in charger. An alternative method is through the DC power outlet using the provided 12 Volt Male-Male Extension Cord.
Charging using the built-in charger (recommended method). With this method, an extension cord (a standard extension cord, not included, for model JNCXF; the provided 2-pin extension cord for model JNCXFE) is connected to the Jump-N-Carrythrough the built-in charger located on the front of the unit.
1.Connect the female end of the appropriate extension cord to the charger plug on the front of the unit.
2.Connect the male end to the extension cord to the AC outlet.
3.Charge the unit based on the suggested recharge times shown in the following table.
