T-Tech JNCXFE instruction manual Battery Replacement and Disposal, Removal instructions

Battery Replacement and Disposal

This unit contains a sealed non-spillable lead-acid battery.

This battery must be recycled. Consult your state or local Pb government concerning regulations for proper disposal.

The battery inside this product is a sealed lead-acid battery. It is required by law to be removed and recycled or disposed of properly. While there are federal regulations that must be complied with throughout the United States, your individual state or local governments may have additional regulations to be followed.

When the battery in this product is in need of replacement, remove it according to the instructions provided below and take it to your local recycling center for proper recycling or disposal. If you don’t have a local recycling center that handles sealed lead-acid batteries, contact your local environmental agency for instructions.

Removal instructions:

Begin by making sure that both clamps are securely placed in a position that ensures they will not come into contact with each other.

1.Lay the Jump-N-Carrydown on its front. On the back of the unit, locate the screws that hold the back panel in position.

2.Remove the screws, then lift off the back panel.

3.On the top of the battery are two terminals, each with wires connected to them. Disconnect these wires from the battery by removing the bolts that hold them to the battery terminals. To prevent accidental arcing, be careful not to touch both battery terminals with the tools being used to remove the bolts.

4.Lift the battery(ies) out of the case.