Craftsman G8693 instruction manual Maintenance, Belt Replacement

SECTION 5: MAINTENANCE

Keep your Mini Shaper clean and adjusted prop- erly for maximum performance and machine longevity. Do not allow pitch to accumulate on the table, fences or cutters. Clean frequently with Gum and Pitch Remover.

The table and other non-painted surfaces on the Model G8693 should be protected against rust and pitting. Wiping the Shaper clean after every use ensures that moisture from wood dust isn’t allowed to trap moisture against bare metal sur- faces.

Some woodworkers recommend using automo- tive paste wax on exposed steel and cast iron surfaces. The wax provides a layer of protection, as well as reducing friction between lumber and the table, making cuts faster and smoother. Avoid waxes that contain silicone or other synthetic ingredients. These materials can find their way into lumber that’s being worked, and can make staining and finishing difficult. If you use paste wax, make sure that it’s 100% Carnauba wax.

For your safety, turn the Mini Shaper off, remove the switch key and disconnect the machine from power source before attempting any repairs or maintenance on the shaper. Failure to observe this will result in serious personal injury.

Belt Replacement

Replacement belts are available from Grizzly Parts Department.

1.Turn the Mini Shaper off, remove the switch key and unplug!

Failure to unplug your Mini Shaper could result in accidental starting and serious injury and that would be bad.

2.Turn Mini Shaper upside down on a firm work surface. Be careful to remove or protect the Stub Shaft from damage.

3.Remove Belt Guard (REF 47) by loosening the mount screw (REF 49).

4.Remove old Timing Belt (REF 46) by turning belt and applying outward pressure.

5.Install new belt by starting it on pulleys and maintain inward pressure until full width of belt is on both pulleys.

6.Should the belt tension need adjustment, loosen four hex head bolts (REF 61) on Motor Mount (REF 54). Slide Motor Mount in or out until sides of timing belt are straight between pulleys. NOTE: Do not over-tension this belt, it only needs to be straight. Excessive tension may shorten the life of the motor bearings. Tighten bolts and make sure the belt runs straight and true.

7.Replace the belt guard before operating.

Figure 20.

G8693 Mini Shaper -23-