SECTION 4: ASSEMBLY
Spindle Shaft
For Your Own Safety, Never Connect To Power Source Until All Assembly Steps Are Complete, And You Have Read And Understand The Safety And Operational Instructions.
Typically, the Spindle Shaft is already installed from the factory. To remove the Spindle, reverse the following steps.
1.Place the Shaper Nut (REF 36) onto the Spindle Shaft (REF 35) and insert the Shaft into the Spindle Bore. See Figure 2.
2.Shaper Nut must be screwed onto the thread- ed portion of the Spindle Bore.
Spindle Shaft
Shaper Nut 
Spindle Bore
3.Lock the assembly in place by tightening the Shaper Nut with the wrenches provided. See
Figure 3.
NOTE: If you would like to use Router bits instead of Shaper cutters, see section on “Using Router Bits” for instructions.
Figure 3. Tightening Spindle.
Figure 2. Set Spindle into hole.
G8693 Mini Shaper |
