In this section you record a point-to-point call that is routed through the IP VCR. A point-to-point call is one
where just two endpoints are involved so you will need two endpoints to work through this section. The IP
VCR must be configured to register a prefix with the H.323 gatekeeper for point-to-point recording to work.
Recording of point-to-point calls is transparent. To start a recording call another endpoint by dialing the
prefix followed by the endpoint number. The recording stops when the call is disconnected.
Before making the first point-to-point call with an H.323 endpoint, check the IP VCR’s Gatekeeper settings.
1 Go to Settings > Gatekeeper
2 Check that the Point to point incoming prefix is set to 71
You are now ready to place a point-to-point H.323 call via the IP VCR. For example endpoint A might have
the IP address 10.2.134.222 and be registered with the gatekeeper with number 5555 and endpoint B could
have an IP address of 10.2.133.203 and number 7777.
When you place the call you dial the IP VCR Point-to-point call incoming prefix before to the number
of the destination endpoint.
Note. Recording SIP point-to-point calls is not currently supported.
3 From endpoint A, place a call to 717777
71 is the registered prefix of the IP VCR that you set up previously and 7777 is the number of the
endpoint that you are calling
4 Answer the call on the receiving endpoint
The IP VCR starts recording both sides of the call once the call has connected.
15