OPERATION AND FUNCTIONS
DAB tuning
When the unit is turned on for the first time, all settings will be default settings. The settings can be changed according to your preference. When the unit is turned off the next time, these settings will naturally be saved as the new default settings. This also applies if you unplug the unit.
CONTROL/TUNING
| When the unit has been turned on, channels |
|
|
| must be saved. This is done by means of the |
|
|
| autotune function. | 1 | 234 DAB/FM AUTOTUNE INFO |
1 | To use the autotune function through the front | 1 | PRESS TO SELECT |
|
| ||
| panel controls, press the AUTOTUNE button |
|
|
| for two seconds. An international search will |
|
|
| be initiated. |
|
|
2 You can also press the AUTOTUNE button on |
| + | |
| the remote control for two seconds. |
| 2 |
|
|
|
Note:
If the button is only pressed once, the unit will once again search for the channels already found.
The message SEARCHING will be shown at the |
|
|
|
|
bottom of the display, and you will see a bar at the | 00000 |
|
|
|
top of the display that grows longer indicating how |
|
|
| |
far the tuning process has come. As it finds | Searching |
|
|
|
channels, you will see a figure at the top line to | 2 |
| 4 | DAB/FM AUTOTUNE INFO |
1 | 3 |
the right of the display that shows how many channels have been found.
If no channels are found, you must check if the antenna has been correctly connected. You can do this by tuning in on a channel through manual tuning on the FM band, and then press the INFO button to display the signal bar and check the signal strength (see the section on FM tuning)
00000000000000010 searching
1 | 2 | 3 | 4 | DAB/FM | AUTOTUNE | INFO |
Saving and selecting channels |
|
|
|
| |||
1 If you want to save a channel under one of the |
|
|
|
| CONTROL/TUNING | ||
four presets, you must press down the button with |
|
|
|
|
|
| 2 |
the number concerned for two seconds. When the |
|
|
|
|
| ||
|
|
|
| ||||
channel has been saved and you wish to listen to | 123 | 4 DAB/FM AUTOTUNE INFO | |||||
1 |
|
|
| PRESS TO SELECT | |||
|
|
| |||||
|
|
|
that channel, press the button with the number that you have saved the channel under. The procedure is the same for both FM and DAB.
2Channels that have not been saved can be selected either by means of the SCROLL buttons on the remote control or the CONTROL/TUNING button on the front panel. Note that if the channel is selected by means of the CONTROL/TUNING button, you must confirm your choice by pressing the adjusting button. This function can be deactivated by pressing the button for two seconds.
+
2
1
15