Tascam CC-222MK owner manual Intro check, Auto spacing, Repeat playback, To B repeat playback

4- Disc operations

Repeat playback

The unit can repeat the whole of the disc, the current track only, or an A–B portion set as described here. Selecting the repeat mode is only possible using the remote control unit.

NOTE

You can use this mode with Single, Random, or Program playback modes.

1The unit should be in playback, standby or stop mode.

Press the REPEAT key so that the display shows Repeat ON (the REPEAT indicator lights).

To cancel repeat mode, press the REPEAT key again so that the display shows Repeat OFF and the REPEAT indi- cator goes out.

A to B repeat playback

You can set the points between which playback should loop.

1While playing back, press the A-Bkey on the remote control at the point where the loop is to start (A-point).

The REPEAT indicator lights up and A-Bindicator blinks till the second point (B-point) is entered.

2Press the A-Bkey again at the point where the loop is to end (B-point).

NOTE

If the A and B points are too close together, A-B looping is not possible.

Playback jumps back to the first “A-point” and continues to the second “B-point” and then re- turns to the “A-point” again, repeating the loop.

Cancel the A-B repeat mode by pressing the A-Bkey, or the stop key. Both indicators will go out.

During playback, if the A-Bkey is pressed, the loop will be canceled and playback will continue past the B-point.

NOTE

A-B repeat cannot be set when the specified sec- tion spans more than one track, and cannot be used with MP3 discs.

Intro check

You can skip through the first 10 seconds of all the tracks on a CD to check the contents of the CD.

2Press the intro check key again or the STOP key to stop this playback process.

NOTE

This function is only available from the remote con- trol unit.

1When stopped, in the Continuous (normal) mode, press the INTRO CHECK key.

The first 10 seconds of each track on the disc will be played back.

NOTE

In Single or Random playback modes, with the disc stopped, pressing the INTRO CHECK key can- cels the mode and returns to Continuous playback mode.

Auto spacing

This function inserts a gap of about four seconds between tracks on playback. This can be useful when recording to tape, so that automatic searching can take place more easily on tapes recorded from disc (see “Search keys” on page 32).

NOTE

This function is only possible using the remote con- trol unit.

Press the auto space key when in playback, standby, or stop mode, the A.SPACE indicator lights on the right side of the display. Pressing the auto space key again cancels the mode and returns to normal playback.

The stop key also cancels the mode and stops play- back.

18 TASCAM CC-222MKIII