5- Recording CDs
Synchronized recording
Synchronized recording basically means that recording will begin automatically when a signal is received, and will stop when the signal ends.
To enable or disable synchronized recording:
1A recordable disc must be loaded.
2With the unit in record standby mode or record mode, press the SYNC REC key.
The display shows SYNC ON briefly, and then changes to the track and time display. When syn- chronized recording is enabled, the SYNC indica- tor lights in the display.
The SYNC REC key is also used to turn off syn- chronized recording.
Automatic track division
The trigger level can also be used to divide tracks if the auto track function is enabled.
NOTE
When recording Vinyl to CD, since the track divi- sions are determined by relative silence, it is pos- sible that spurious track divisions will be inserted. Under these conditions, it may be better to set this function off, and use manual track division explained below.
•TIME
The track will be incremented as passing the time set before recording using “A_TIME” in the menu items (see “Menu operation” on page 15). The time can be set 1 minute to 10 minute increased by a minute.
•OFF
This sets the function disabled (no indicator lit).
When this function is enabled, the unit automatical- ly inserts a track division in the recorded material. Following modes are available for this function, and are displayed as described.
•LEVEL
When the sound level has dropped below the thresh- old for more than two seconds, and sound has
| At least |
|
level | 2 seconds | Track increment |
|
| |
A_LVL |
|
|
|
| time |
•DD (digital direct)
When recording digitally from MD, CD or DAT, this mode detects a track boundary and divides the track.
However, when the DD mode is on, and if the analog source or
ªTo enable or disable automatic track division:
1 While record standby mode, press the MENU key repeatedly until the display shows A_TRK> XXX where XXX is the current setting.
2Use the MULTI DIAL or SKIP keys to select the desired auto track setting.
The A_TRACK indicator lights at the right of the display.
When the TIME mode is selected, the indicator will blink.
Manually divide track
While recording is taking place, press the RECORD key. The current track number is incremented by one.
NOTE
This operation cannot be applied while recording track 99.
TASCAM
