4- Disc operations
Simple playback operations
WARNING
If you are monitoring using headphones, first adjust the level control to low on the unit, then connect to the PHONES jack before playing back. This will pre- vent any possible damage to your hearing.
1Press the OPEN/CLOSE key to open the disc tray.
2Discs should be inserted in the tray with the label uppermost.
3Press the OPEN/CLOSE key to close the tray.
When a disc is loaded into the unit, the display briefly shows TOC Reading., with a flashing period as the unit determines the contents of the disc. When the TOC has been read, the display shows (at the left of the dis- play) one of the following:
4Press the PLAY key to start playback
5 Press the STOP key to stop playback
6Press the PAUSE key to pause playback tempo- rarily.
To resume playback, press the PAUSE key again or the PLAY key.
The track number indicators at the bottom of the dis- play light, to show the available tracks playing back. If there are thirteen tracks on the disc, for example, indicators 1 through 13 will light. If there are more than 20 tracks on the disc, “OVER” will light at the end of the track number indicators.
CD | Commercial |
Finalized | |
Time display modes
When playing back a CD, or when in standby mode, there are four different time display modes.
In each mode, the current track number is given, fol- lowed by the time, as given below, e.g.
10Tr 0:48
Press the DISPLAY key to cycle through these time dis- play modes, as described here:
Display shows | Meaning |
TOTAL | Total elapsed time of the disc |
TOTAL REMAIN | Time remaining of the current disc |
[blank] | Elapsed time of the current track |
REMAIN | Time remaining of the current track |
NOTE
If the Program playback has been selected (see ”Program playback” on page 17), the elapsed time and total remaining time refer to the programmed material, not the whole disc.
Track search
Use the MULTI DIAL (or the SKIP keys on the remote control unit) to jump forward or backward by one track at a time, as shown on the display.
Note that going forward from the last track of the disc will “wrap round” to track 1, and going backward from the first track of the disc will “wrap round” to the last track of the disc.
It is also possible to use the number keys on the remote control unit to jump directly to a particular track:
1To play tracks 1 through 9, simply press the ap- propriate key (1 through 9).
2To play a track whose number is higher than 9, press the +10 key an appropriate number of times to set the“ tens” digit of the track number,
followed by a single key to set the“ units” digit. For example:
Track 13 = +10, 3
Track 30 = +10, +10, +10, 0
NOTE
On the remote control unit only, the search keys can be used to
16 TASCAM
