1 – Introduction

Use of the remote control unit

•• Do not expose the infrared receiver (light receptive area on the front panel) to direct sunlight or intense light for extended periods of time. Long exposure to this light may result in failure of the remote control sensor.

•• When the remote control will not be used over one month, please remove the batteries to prevent the possibility of battery acid leakage which could damage the unit. Should leakage occur, remove and discard the batteries, and wipe the battery case thoroughly with a cloth. Avoid getting the battery liquid on the skin. After cleaning, replace with new batteries.

•• The remote control functions by using an infrared light signal. When using the unit to control the CC-222SLMKII, other devices that are turned on could be operated by its signal.

•• If the range of remote operation becomes smaller, or commands do not always function properly, the batteries have become weak and should be replaced. Always replace both batteries with new batteries of the same type.

•• Point the remote control to the remote sensor on the main unit. Do not obstruct the path between the remote control and the remote sensor.

Batteries

If batteries are used improperly, or if leakage or breakage occurs, the unit will not function.

Please observe the cautions indicated on the batteries and their packaging to ensure proper usage.

•• Confirm + and – polarity and follow the indications when inserting new batteries into the remote control.

•• Do not use old and new batteries together.

•• Even if the battery is the same size, the voltage may differ. Do not use batteries of different specifications together.

•• Do not at tempt to recharge bat ter ies that are non-rechargeable.

•• Do not open or disassemble batteries, throw them into a fire or put them in water.

ªª Inserting batteries

1.Open the lid.

2.Confirm +/- polarity, and insert two AA batteries.

3.Close the lid.

NOTE

The batteries are not supplied for Taiwan.

10 TASCAM CC-222SLMKII