51 – RecordingIntr ductionCDs

Dubbing from tape to disc

When dubbing from tape to disc, follow the instructions here.

1Load the tape with the side that will be recorded first to be played first. Set the noise reduction, reverse mode, etc. Also, check the monitor is set DISC.

2Load a recordable disc.

3Use the MENU key until DUB>VOLappears on the screen. Use the multi dial to select THRUto bypass the input level control (see “Bypassing the input level for dubbing” on page 24).

If you want to adjust the input volume, set the DUB>VOLmenu to ONand use the CD deck’s INPUT control to adjust the level of signals. If you wish to adjust the volume before recording starts, put the CD-RW into record standby or Monitor mode (see “Input monitoring on page 21”) and use the INPUT 1 SEL key to select TAPE.

4Press the DUB 1 key.

The CD goes into record standby. The tape rewinds to the start of the tape and starts playing back. The CD recorder starts recording.

5When the available recording time on the disc is finished, or the tape has stopped, then recording will stop on the disc.

You can also stop the dubbing process by pressing either of the STOP keys.

NOTE

A recordable disc must be loaded in the drive. The DUB 1 key is disabled if the media are not loaded, and if the drives are in any mode other than stop.

Dubbing to CD from the middle of the tape

1To record from the middle of the tape, set noise reduction, reverse mode, etc. and locate the tape to the position where playback will start.

2Press the tape PAUSE key to leave the tape in paused mode.

3With a recordable disc in the drive, press the DUB

1 key. The tape will start playing back, and the disc will start recording.

Recording stops under the same circumstances as for the whole tape (end of tape, end of disc or either STOP key pressed).

Bypassing the INPUT level for dubbing

The input control can be bypassed so that it has no effect when dubbing, in the following way:

1Press the menu key until the DUB>VOLitem ap- pears.

2Turn the dial to select THRU, the control is bypassed and disabled.

NOTE

This setting applies only to dubbing procedures, not to other recordings.

It is not possible to make this menu setting (or other menu settings) when dubbing is actually taking place.

24 TASCAM CC-222SLMKII