18 — TASCAM CD-BT1MKII
(continued from the previous page)
CAUTION
If you set the key control to O6 while the fine
tuning value is greater than 0, the fine tuning
value is automatically reset to 0. Similarly, if
you set the key control to I6 while the fine
tuning value is less than 0, the fine tuning
value is automatically reset to 0.
Also note that when key control or VSA is
ON, you may find that the music played back
has a “vibrato” feel. This is not a fault of the
CD player – it is a natural result of the special
effects.
Using CD effects

Turning CD effects on and off

Pressing the
CD EFF
switch at the side
of the CD-BT1MKII turns on the pre-
set CD effects: guitar cancel, mono
monitor, split monitor. ese three CD
effect components can be used simulta-
neously. e
CD EFF
symbol is shown on
the display. Press the
CD EFF
switch
again to turn off the CD effects.

BEE (Bass Enhancement Effect)

BEE reduces or enhances the bass com-
ponent of the CD playback.
Press and hold the
TMP/KEY / CD EFF
key to enter the CD Effect menu. Press
either the
PREV
or
NEXT
key to choose
BEE
. Press either the
UP
or
DOWN
key
to select from the choices listed below:
OFF
: normal playback (the sound is
not affected in any way)
BST
: the bass component of the
sound will be boosted
ENH
: th e bass component of t he
sound will be boosted and the
definition of the bass pa rt of the
music will be enhanced
CUT
: bass component of the sound
will be cut out

Mono monitor

Setting the monitor mode allows you
to control the output signal between
mono and stereo with alternate options
for both.
Press and hold the
TMP/KEY / CD
EFF
key to enter the CD Effect menu,
and select
MONO
by pressing either the
PREV
or
NEXT
key. Press either the
UP
or
DOWN
key to select from the
following:
L+R
: outputs a mono signal, mix-
ing the L (left) and R (right) chan-
nels.
L
: out puts the L cha nnel signal
only.
R
: outputs the R ch annel signal
only.
OFF
: outputs normal stereo signal .

Split monitor

Setting the split monitor mode allows
you to split the CD output and the bass
guitar into left and right outputs.
Press and hold the
TMP/KEY / CD EFF
key to enter the CD Effect menu, and
select
SPLT
by pressing either the
PREV
or
NEXT
key. Press the
UP
or
DOWN
key to select from the following:
C-B
: outputs the sound of the CD
from the left, and the sound of the
bass guitar from the rig ht.
B-C
: outputs the sou nd of the ba ss
guitar from the lef t, and the CD
sound from the right.
OFF
: outputs stereo mixed sound of
CD and bass g uitar from left and
right.
Using CD effects