Taylor 220 - page 17

Model 220 Operating Procedures

Slide the o--ringinto t he groove on the bearing holder,

and lubricate.

Figure 9

Lightly lubricate the draw rod, and slide the bearing

holder onto the rod, locking stem first.

Figure 10

Thread the valve piston on the end of the draw rod until

tight.

Figure 11

Lightly lubricate the inside of the valve body in the

freezer door.

Figure 12

Insertthe draw rodassembly,valve piston first, into the

valve body.

Figure 13

Turnthe draw rod handle to loc k the bearing holder into

place.

Figure 14

Contents

Main Page Table of Contents Table of Contents -- Page 2 Section 1 To the Installer Installer Safety S Site Preparation Air Cooled Units Water Connections Electrical Connections S Beater Rotation Refrigerant Section 2 To the Operator Compressor Warranty Disclaimer Section 3 Safety S 7 Model 220 Operator Parts Identificati on Section 4 Operator Parts Identification 8Model 220Operator Parts Identificati on Beater Door Assembly Accessories Section 5 Important: To the Operator Symbol Definitions Control Switch Dial Light Temperature Control Section 6 Operating Procedures Assembly Page Page Page Sanitizing Page Priming Page Overrun Drawing Product Closing Procedures Rinsing Cleaning/Sanitizing Disassembly Brush Cleaning Page Section 7 Important: Operator Checklist During Cleaning and Sanitizing Troubleshooting Bacterial Count Regular Maintenance Checks Winter Storage Section 8 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PAG E REF. Section 9 Parts Replacement Schedule Section 10 Parts List HP62 -- J5083472/Up