
17
Model C300 Important: Tothe Operator
Syrup Out IndicatorAUTO MODE AUTO
OUT SYRUP OK
CO2- OK WATER-OK
If the word “OUT” appears in one of the columns
next to the word “SYRUP”, it indicates a lack of
syrup or syrup pressure being supplied for the
indicated freezing cylinder. If the unit is in the AUTO
or PRIME modes, the product light will illuminate
and a warning tone will sound for that freezing
cylinder. At this time, replace the appropriate
bag- in- the- box. A s a saf ety feature, the
refrigeration system automatically stopst o preventa
freeze- up in the freezing cylinder.
If a syrup out condition occurs on one side, that s ide
will enter the HOLD mode at which time refrigeration
remains off, the beater continues to run, and the
CO2solenoid is closed for that side to prevent the
dispensing of product. The opposite side will not be
affected.
CO2Out IndicatorAUTO MODE AUTO
OK SYRUP OK
CO2- OUT WATER-OK
On the LCD, if the word “OUT” appears next to t he
word “CO2” it indicates a lack of CO2being supplied
to the freezer. The product light will also illuminate
and a warning tone will sound. This will continue
until the CO2is replaced. If the CO2is not replaced
within one minute, the machine will shut down and a
fault message will appear.
Water Out IndicatorAUTO MODE AUTO
OK SYRUP OK
CO2- OK WATER-OUT
On the LCD, if the word “OUT” appears next to t he
word “WATER”, it indicates a lack of water being
supplied to the freezer. In addition, the product light
will illuminate and a warning tone will sound. This
will continue until the proper amount of water is
supplied to the freezer. If the water is not supplied
within one minute, the machine will shut down and a
fault message will appear.
Audio Alarm SilencerThe audio alarm will be disabled if the ALARM
SILENCE key is pressed. If a new fault or fault
condition occurs or the system mode changes, the
audio alarm will be re- enabled automatically. If the
audio alarm is silenced for greater than 30 minutes
without correcting the fault, it will be re- enabled
automatically.
Product LightWhen the light is continuously lit (not flashing) it
indicates that there is an “OUT” condition for syrup,
water, or CO2.
When the light is flashing, it indicates that the
product is not at serving viscosity. This will occur
during the initial freeze down,a defrost cycle and a
FAULT condition and during power saver modes.
Sampling ValveThe sampling valve is located behind the lower front
panel. The sampling valve is used to obtain a brix
reading.
Daily ProceduresThe following procedure should be performed daily.
Remove the splash shield and front drip tray. Take
these parts to the sink and brush- clean them.
Re- install the parts onto the freezer. Use a clean,
sanitized towel and wipe down the front of the
machine, including the doors and spouts.