B_DPL580 EN | 4/16/04 12:52 PM Page 7 |
Getting Started
Inserting Batteries into Remote Control
Insert two “AAA” (R03) batteries according to the + and
-signs in the battery compartment. To use the remote control, point it directly at your receiver.
Install batteries as follows:
1.Remove battery compartment door by applying thumb pressure on battery door and then lift the door out and off the cabinet.
2.Insert 2 AAA batteries in the compartment and replace the compartment door.
Set up and Maintenance of the Receiver
Provide spaces for sufficient ventilation as indicated:
| 10 cm/4" |
|
10 cm/ | Front View | 10 cm/ |
4" |
| 4" |
| 10 cm/4" |
|
5 cm/ |
|
|
2" | Side View |
|
•Do not connect to the AC power cords until all connections are completed.
EN
•Do not use your set immediately after transferring it from a cold place to a warm place: there is risk of condensation.
•Do not expose your set to water and excessively high temperatures.
•After having disconnected your set, clean the case with a soft cloth, or with a slightly damp leather chamois. Never use strong solvents.
Protect your Components from
Overheating
•Do not block ventilation holes in any component. Arrange the components so that air can circulate freely.
•Do not stack components directly on top of each other.
•Do not place the unit near other components that generate heat such as heating vents.
•Allow adequate ventilation when placing your components in a stand.
•Place an amplifier near the top shelf of the stand so heated air rising from it will not affect other components. If you have a satellite receiver, you should place it on the top shelf.
3
