Technicolor - Thomson IFC130 manual Programming the volume control function, Manual programming

IFC130-P_EN 5/08/05 9:48 Page 5

Getting started

Manual programming

This method involves carrying out a manual search for the codes to be used for controlling your other appliances.

1.Switch on the appliance you wish to use the remote control with.

2.Press the relevant button for this appliance on the remote control, and while holding this button down, enter one of the codes relevant to your make of appliance (there is a list of

codes at the end of this manual). If the light ( or the appliance buttons) of the remote control flash you have entered the wrong code or it is not possible to program the remote control.

3.Point the remote control at the appliance and press the

relevant button (VCR, DVD, etc). Press the standby button. If the appliance does not go into standby mode, try another code.

Depending on the year of manufacture and the type of appliance, some functions may not be available. Certain codes may cover more functions than others.Test the functions you can control and, if appropriate, try other codes. Note here the code(s) which work best.

VCR	AUX
DVD	AMP
SAT

When you change the remote control’s batteries, remember to reprogram it.

Programming the volume control function

If you have programmed the TV remote control to use with other appliances and these are connected to an amplifier you can also programme the remote control to adjust the volume when you are using one of these appliances.The example below describes the procedure for programming a DVD player.

1.	Programme the AMP button on the remote control to use
	with the amplifier (refer to page 4).
2.	Move the remote control away from the appliances. Press the
			EN
	- button and while holding it down, press the relevant
	mode button (DVD, in this example), then the AMP button.
	Release the	- button.

3.Switch on the amplifier, then the DVD player.

4.Set the remote control to DVD, play a disc and adjust the volume using the +/- buttons.

Repeat this operation for the other appliances.

To cancel the programmed function for any of the appliances, press the - button, while holding it down and enter the code 000 using the numeric buttons.

	Video recorder	DVD player		Satellite receiver		Hi-fi system
	Press the VCR button.	Press the DVD button.		Press the SAT button.		Press the AMP button.
	On/Standby	On/Standby		On/Standby		On/Standby
MENU	To display the main menu	To display the main menu		To display the main menu
	Vertical scrolling in menus	Vertical scrolling in menus		Vertical scrolling in menus
	Horizontal scrolling in menus	Horizontal scrolling in menus		Horizontal scrolling in menus
OK	To confirm an action	To confirm an action		To confirm an action
EXIT	To close a menu	To close a menu		To close a menu
0-9	To directly access channels	To enter numeric values		To directly access channels		To select a station using
	or enter numeric values	or select options in menus		or enter numeric values		its number
PR+/PR-	To change channels	To change chapters		To change channels		To change stations
AV	To select AV input	To select AV input
REV	Rewind	Rewind
PLAY	Play	Play
FWD	Fast forward	Fast forward
STOP	Stop	Stop
PAUSE	Pause picture	Pause picture
REC	Record
or						To switch the sound off and
						back on again
+/-						To set the volume level
			Important:
			If the batteries in your remote control are run down you can use the
			buttons on the front of your TV set. In TV mode, they have the same
			functions as the corresponding buttons on the remote control. In the
			menus they have the following functions:
				PR 
				PR 
				VOL 	or OK
				VOL 	or OK
				MENU	To confirm a selection

5