Chapter 2
Basic Installation
Finishing the Home Install Wizard
The Home Install Wizard will configure the Thomson Gateway and your computer according to the service profile. Proceed as follows:
1You can follow the configuration progress in following window:
2Click Finish to close the wizard.
The following steps will happen automatically:
After some seconds, the Internet LED on your Thomson Gateway will be lit green to indicate Internet connectivity. If not, refer to “4.2 LED Diagnostics” on page 27. If needed, you can test your Internet connection as described in “ Testing your Internet Connection” on page 29.
The CD Menu is displayed. See “2.3 The Setup CD” on page 17 for more information.
You are redirected to the embedded Thomson Gateway pages automatically (unless you cleared the http://dsldevice.lan check box in the last window of the Home Install Wizard). These pages allow you to configure the Thomson Gateway firewall, Thomson Gateway settings, and so on. See the User’s Guide for more information.
More on IP settings
In most cases, the computer’s networking interface used during the Home Install Wizard procedure will be configured for obtaining its IP configuration dynamically. This is the most convenient configuration and should not be changed.
i
For fixed or advanced IP configurations, please follow the instructions of your ISP.
14 | |
|
