
1
1 2 2 3
Before use
CLOCK/TIMER
A
1 H/I
2 1 CLOCK/TIMER
2
SET
3 1 ? TUNING @
2
SET
B
CLOCK/TIMER
C
1 MODE
2
MODE
RQT5471
»A Setting the time
This is a
The example shows how to set the clock for 16:25 (4:25 p.m.).
1 Press [ê/I] to turn the unit on.
2 1 Press [CLOCK/TIMER,
Each time you press the button:
CLOCK>FPLAY>FREC>Original display
} |
2Within 7 seconds
Press [SET].
3 1 Press [TUNING (X or W)] to set the time.
The time display can be changed in one minute units by tapping the buttons, and quickly by holding down the but- tons.
2Press [SET].
The time is set and the original display is restored.
Displaying the clock
Press [CLOCK/TIMER,
The clock is shown for about 5 seconds.
»B Turning DEMO off
A demonstration of the display is shown if you have not set the clock. Turn DEMO off to get the most from ECO mode (see below).
While the unit is on:
Press and hold [CLOCK/TIMER,
Each time you press and hold the button:
NO DEMO (off)bDEMO (on)
»Saving power in the standby C mode
Set the unit to reduce energy consumption in the standby mode (11 W>0.5 W for the United Kingdom, Continental Europe, Russia, Australia and N.Z. or 11 W>1.0 W for others).
While the unit is on:
1Press [MODE].
The current mode is displayed.
2Within 5 seconds
Press [MODE] to display “ECO”.
Each time you press the button:
NORMAL (off)bECO (on)
ECO: The clock is not displayed in the standby mode. The “ê” and the “FPLAY/FREC” indicators still light.
Note
The mode can be switched to ECO when the unit is in standby but it cannot be switched back to NORMAL.