Technika LCD19-919 manual Using Side AV Connectors, Connecting Other Equipment Via Scart

Models: LCD19-919

1 31
Download 31 pages 43.35 Kb
Page 10
Image 10

Using Side AV Connectors

You can connect a range of optional equipment to your LCD TV. Possible connections are shown below. Note that cables shown in the illustration are not supplied.

For connecting a camcorder, connect to the VIDEO IN socket and the AUDIO SOCKETS. For selecting the related source, see the section “Input selection” in the following parts.

To listen the TV sound from headphones, connect to the HEADPHONE jack of theTV

Camcorder

Headphone

Connecting Other Equipment

via Scart

Most devices support SCART connection. You can connect a; DVD recorder, a VCR or a decoder to your LCD TV by using the SCART socket. Note that cables shown in the illustration are not supplied. Power off both the TV and the devices before making any connections.

For more information, refer to your device’s own

instruction book.

Scart socket

DVD Recorder

Video Recorder

Decoder

English

Inserting Batteries into the

Remote Control

Remove the battery cover located on the back of the by gently pulling backwards from the indicated part.

Insert two AAA/R3 or equivalent type batteries inside. Place the batteries in the right directions and replace the battery cover.

Note: Remove the battery from remote control when it is not to be used for a long period. Otherwise it can be damaged due to any leakage of batteries.

Switching the TV On/Off

To Switch the TV On

Connect the power cord to the 220-240V AC, 50 Hz. Then the standby LED lights up.

To switch on the TV from standby mode either:

Press the “” button, P+ / P- or a numeric button on the remote control.

Press the “” button, -P/CHor P/CH+ button on the TV. The TV will then switch on.

Note: If you switch on your TV via standby button on the remote control, the programme/source that you were watching last will be reselected.

By either method the TV will switch on.

To Switch the TV Off

• Press the “” button on the remote control or press

the “” switch on the TV, so the TV will switch to standby mode.

To power down the TV completely, unplug the power cord from the mains socket.

Note: When the TV is switched to standby mode, standby LED can blink to indicate that features such as Standby Search, Over Air Download or Timer is active.

- 9 -

MB45_[GB]_1205UK_IDTV_BRONZE11_19882W_10066964_50164988.indd

9

15.02.2010 14:40:13

 

 

 

Page 10
Image 10
Technika LCD19-919 Using Side AV Connectors, Connecting Other Equipment Via Scart, Inserting Batteries into Remote Control