Getting Started - Initial Set Up
GETTING STARTED INITIAL SET UP
1)Using the RF cable supplied, connect the TV to the TV Aerial wall socket (Fig A)
2)Connect the power cable to the Electrical outlet (Fig B)
Fig B
Fig A
3)Switch on the television using the power on/off switch located on the side of the TV.
4)Insert the batteries supplied into the Remote control and press the Standby button to power on the TV
Power on/off
5)You will now be welcomed with the initial
If it does not appear, on the remote control, please press [MENU] then
Press OK on the remote control and tuning will start.
6)After tuning the following screen will appear.
If you are missing channels, the reason for this is likely to be signal strength, you should consider connecting signal booster and
As part of our ongoing development to reduce power consumption, we have added an extra function to this Television called ‘Ecohome’ (you will see this during the first time installation set up). Power consumption using the Ecohome function is approximately 15% lower than some other modes. The picture brightness is reduced using the Ecohome function. If this function is not suitable for your viewing environment, you can select other modes as necessary. (Please note, ‘Professional’ mode is for optimum default picture settings, however, power consumption is approximately 15% higher than ‘Ecohome’ mode)
Please refer to the user guide section ‘Picture settings’ in order to change the mode to one that maybe more suitable for your environment. There is also a shortcut button on the remote control called
11
