V. Removal and Installation-Type “C” Air Cleaner
1.Turn cover to left (counterclockwise) to remove. See Figure 50.
2.Remove paper filter from flange. See "II. Servicing Paper Filters" instructions on page 19. Afterward, con- tinue reading instructions below.
3.Discard paper filter.
4.Clean cover and flange thoroughly.
5.Install new paper filter into cover.
6.Position cover and filter against flange with tab on cover inserted into lower left corner of slot in flange.
7.Push cover firmly against flange and turn to right (clockwise) as far as it will go.
8.Be sure retainers are locked around flange.
34
5 1 6
2
1
1. Retainer
2.Slot
3.Flange
4.Paper Filter
5.Tab
6.Cover
Figure 50. Air Cleaner Type “C” Assembly
VI. Removal and Installation-Type “D” Air Cleaner
1.Remove cover by pulling tab “A” away from body while lifting cover upward. See Figure 51.
2.Inspect filter(s) for discoloration or dirt accumulation. If either is present, see "I. Servicing Foam Filters" instructions on page 18 and "II. Servicing Paper Filters" instructions on page 19. Afterward, continue reading instructions below.
3.Discard paper filter.
4.Clean inside of cover and body thoroughly.
5.Install foam filter(s) and new paper filter.
6.Install cover by hooking slot of cover over tab “B” on body.
7.Push cover down, snapping cover onto body securely.
5
4
3
6
2
7
1
1.Tab “B”
2.Foam Filter
3.Slot
4.Cover
5.Tab “A”
6.Paper Filter
7.Body
Figure 51. Air Cleaner Type “D” Assembly
Page 20 |
