7.If engine fires but does NOT continue to run, move engine throttle control to “FAST” position and start engine.

8.If engine fails to start after 3 attempts in the “FAST” position, move engine throttle control to “CHOKE” position and start engine.

9.If engine does NOT start after following steps 1 thru 8, contact your Authorized Tecumseh Servicing Dealer. DO NOT attempt to start or troubleshoot this engine in any other way.

B. Engine Sections with Recoil Starters

Only one of the following three sections will apply to your engine. See Table 4.

I.Primer Bulb Only

1.To avoid carbon monoxide poisoning, be sure engine is outdoors in a well-ventilated area.

2.Move engine throttle control to “FAST” position, if present (see equipment manufacturer’s instructions). See Figures 21, 22 and 23.

Table 4. Engine Sections with Recoil Starters

If your engine has:

Go to:

 

 

 

 

Primer Bulb Only

Section B.I

 

 

Choke Only

Section B.II

 

 

Primer Bulb and Choke

Section B.III

 

 

3

2

1

1.Starter Cord Handle

2.Engine Throttle Control

3.Equipment Control

Figure 21. Typical Engine Controls

STOP

STOP SLOW RUN FAST CHOKE PRIMER

Figure 22. Typical Engine Symbols

3

2

1

1.“SLOW” Position

2.“RUN” Range

3.“FAST” Position

Figure 23. Start/Choke Control Positions

Page 10

Four-Cycle Engine • Vertical Crankshaft • Air-Cooled

181-1215-14

Page 12
Image 12
Tecumseh LV148XA, LV148EA specifications Engine Sections with Recoil Starters