1800128603_01_FV96XXE0_110X154 20/12/12 11:30 PAGE3
•If you are ironing a fabric comprising a mixture of fibres: adjust the temperature to the most delicate fibre.
•If you put your thermostat in the “MIN” position, the iron does not become hot.
|
|
| Using the water spray trigger (spray) |
Check that there is |
| ||
• When ironing with the steam or dry function, press the spray trigger several times | |||
water in the tank before | in succession to remove stubborn wrinkles – fig.6. | ||
using the spray trigger. |
|
|
Obtaining more steam
•Set the thermostat control to “MAX” or “•••”.
•Press the turbo steam button from time to time – fig.7.
•To avoid water dripping onto your clothes, wait a few seconds before pressing again.
Smoothing garments vertically
Hold the iron a few | • Hang the garment on a hanger and hold the fabric using one hand. The steam | |
centimetres from the | is very hot so you should always do this with the garment on a hanger – never | |
fabric so as not to burn | while someone is wearing it. |
|
delicate fabrics. | • Set the thermostat control to “MAX” – fig.8. | |
| • Pulse the turbo steam button | – fig.7 and move from top to bottom – fig.9. |
Dry Iron function
•Adjust the temperature to the fabric being ironed.
•Set the steam control to – fig.1.
•You can iron when the light goes out.
Additional functions
Gliss/Glide ProtectTM autoclean soleplate(depending on model)
•Your iron is equipped with a catalytic
•Its exclusive coating permanently eliminates impurities generated during normal use.
•It is recommended that you always rest your iron on its support base to preserve its
Auto-stop safety function (depending on model)
In normal use, the auto- • The electronic system cuts the power and the
stop light is on! is placed on its support base for more than 8 minutes or left flat for more than 30 seconds – fig.10.
• To restart the iron, simply shake it gently until the light stops flashing.
Anti-drip function
•The automatic steam selection function is based on the fabric being ironed, which is integrated into your iron, reduces the steam flow at low temperatures and prevents the iron from dripping onto your clothes.
Cleaning and maintenance
Descale your steam iron easily
Do not put any descaling products (vinegar, industrial descaling agents...) to rinse out your iron: they could damage it.
•To prolong the steam performance, your iron is equipped with an integrated limescale collector. This collector, which is located on the iron's support base, automatically collects limescale that forms inside the iron.
•It is recommended that you clean the collector every 4 months. The amount of scale collected will depend on the hardness of the water.
•BE CAREFUL: this operation should only be carried out when the iron has been unplugged for more than one hour and has cooled down completely. To carry out this operation, the steam iron must be close to a sink so that water can flow from the tank when opened.
•Hold the iron in one hand and tilt it slightly, pointing the soleplate upwards.
RU
PL ET LV3
LT