Filling the boiler during use, Cleaning the unit

Never unscrew the boiler cap while it’s still steaming.

Filling the boiler during use

• VERY IMPORTANT : Before opening your boiler, ensure that there is no more
steam left inside by pressing the steam control button (B) located on the handle
of the iron and keep it pressed down until there is no more steam.
• Stop the generator by pressing the on/off switch and unplugging the plug.
• Slowly unscrew the boiler cap.
• Using a water jug, fill with maximum 1 litre of water.	ENG
• Fill the boiler, taking care that the water does not spill over. If this occurs,	ENG
remove the excess water.

•Replace the boiler cap, screwing on tightly. Plug your generator into the mains, and switch it on.

•Wait until the boiler heats up. After approximately 8 minutes or when the steam ready indicator light comes off, the steam is ready.

•Turn off at the main switch and unplug.

•Wind the electric cord around the cord tidy (D).

•Place the iron on the rest.

•Storing the steam cord (E).

•Leave the steam generator to cool down before putting it away if it is stored in a cupboard or confined space.

•You can store your steam generator in complete safety.

Before cleaning, ensure that your steam generator is unplugged and that the soleplate and the iron rest have cooled down.

Do not use detergent or descaling products for cleaning the soleplate or the base unit.

Never hold the iron or the base unit under the tap.

• Regularly clean the soleplate with a non-metallic sponge and warm water.

•Clean the plastic parts of the appliance occasionally with a soft dampened cloth.

	• Be careful : To extend the life of your boiler and to avoid the build up of scale, it
If your water is hard,	is essential that you rinse out the boiler at least after every 10 uses (approxima-
increase the frequency.	tely once a month).
In particular, do not use	• Check that the generator is cold and unplugged for more than 2 hours.
descaling agents for	• Slowly unscrew the boiler cap.
rinsing out the boiler, as	• Using a jug, fill the boiler 3/4 full with untreated tap water.
they could damage it.	• Shake the base unit for a few moments and then empty it completely over
	your sink (F).
	• To obtain the best results, we advise you to repeat this operation.