Tefal GV7315E0 manual Preparation, Use

1800129367 GV73XX E0 A11_110X154 01/03/13 09:50 PAGE80

EN • PLEASE REFER TO SAFETY INSTRUCTIONS AT THE BEGINNING

OF THIS BOOKLET BEFORE USING YOUR APPLIANCE

Description

1.Steam control button

2.Iron temperature adjustment dial

3.Iron thermostat light

4.Iron rest

5.Power cord storage space

6.Power cord

7.Water tank

8.Steam generator boiler (in the base unit)

9.Iron-base steam cord

10.Steam cord storage compartment

Locking system for retaining the iron on the base - Lock system (depending on model)

• Your steam generator is equipped with a retaining hoop which locks the iron on its base for easier transport and storage:

-Locking - fig.1

-Unlocking - fig.2

•To carry your steam generator by the iron handle: - Place the iron on the iron rest of the generator and raise the retaining hoop over the iron until it locks into place (audible click) - fig.1.

- Grasp the handle of the iron to carry your steam generator - fig.3.

Preparation

What water may be used ?

• Tap water :

Your appliance has been designed to function using untreated tap water. If your water is very hard, we recommend you use a mix of 50% untreated tap water and 50% distilled water available in most shops.

• Types of water not to use :

Heat concentrates the elements contained in water during evaporation. The types of water listed below may contain organic waste, mineral or chemical elements that can cause spitting, brown staining or premature wear of the appliance: water from clothes dryers, scented or softened water, water from refrigerators, batteries, air conditioners, rain water, boiled, filtered or bottled water. These types of water should not be used in your TEFAL iron. Also only use distilled water as advised above.

• Always remember :

Never use rainwater or water containing additives (like starch, fragrance or water from domestic appliances). Such additives can affect the steam properties and at high temperature, form deposits in the steam generator chamber which are likely to stain your washing.

Filling the water tank

•Place your steam generator on a stable, flat heat- resistant surface.

11.Scale collector (depending on model)

12.Control panel a - OK button

b - “Steam ready” light

c - “water tank empty” light d - “Anti-calc” indicator

e - ECO mode button (depending on model) f - Illuminated on/off switch

13.Lock-System hoop (depending on model)

•We recommend that you use a mesh type ironing board to allow steam to pass through the garments for better ironing results and also to prevent steam venting sideways.

•Check that your appliance is unplugged and open the flap on the tank.

•Pour in untreated tap water up to the max mark - fig.4.

Using your steam generator

The first time the appliance is used, there may be some fumes and smell but this is not harmful. They will not affect use and will disappear rapidly.

•Completely unwind the power cord and the steam cord from its storage space .

•Tilt the locking ring of the iron forwards to release the safety catch (according to the model).

•Plug in your steam generator to an earthed socket.

•Press on the on / off switch - Fig.14. The green light (located on the control panel) flashes and the boiler heats up - fig.9. When the green “steam ready” light stops flashing (after 2 minutes approximately), the appliance is ready.

•When starting, and regularly while it is being used, your steam generator's electric pump injects water into the boiler. It makes a noise but this is quite normal. You may also hear a clicking noise which is the steam valve opening. Again this is normal.

Use

Steam ironing

Do not place the iron on a metal support.When taking a break from ironing, always place the iron on the iron rest plate of the unit. It is equipped with non-slip pads and has been designed to withstand high temperatures.

•Place the iron's temperature control dial according to the type of fabric to be ironed (see table below).

•The thermostat light comes on. Important: whenever you start using your iron and whenever you reduce the temperature during use, the iron is fully ready for use when its thermostat light goes out and when the green light located on the control panel stops flashing and remains on.

80