
GB Description
aLid with steam diffuser knob (dual position) Open - to release steam when lid resting on paddle
Closed - to retain steam when lid resting on strainer)
bStrainer
cPaddle
d
eMotor unit (e1) with drive spindle (e2)
fControl panel
gLid in steam release position
h3 jam jars with 3 lids
iLadle
Figure 1: maximum filling level of bowl
Figure 2: assembly when making preserves or desserts (programmes P2, P3, P4, P5)
Figure 3: assembly when extracting juice (programme P1) and making jelly (programme P1)
Use
Fitting the knob onto the lid
•Remove the screw from the knob, fit the knob onto the lid and tighten the screw into the knob from the underside of the lid.
Fitting the bowl
•Place the bowl on the motor unit. The bowl must be positioned correctly on the motor unit so that it can operate.
Positioning the paddle and the lid
•Fit the paddle on the central tube in the
•Put the lid on the bowl. To prepare preserves/desserts (fig.g), the steam diffuser must be up in the open position.
Do not fill above the maximum level mark in the bowl (two raised lines) to avoid any overflows during cooking, as certain fruits swell up and froth significantly during cooking.
Important to Note
•The appliance is designed to detect boiling: it only starts the countdown when boiling point is reached.
•The lid has two steam outlets under the knob. When operating, do not place your hand above these outlets.
•The longest cooking cycle is one and a half hours. This is considerably longer than the time required for any cooking preparations.
•Takeextreme care when removing the lid as hot steam escapes from the jam and hot condensed water may form under the lid which can cause scalds.
•If an error message is displayed on the screen (E2, E3, E4), the appliance has detected a problem:
E2 : no ingredients in the bowl.
E3 or E4: internal problem in the appliance.
•To clear the error message, unplug the appliance for at least 30 seconds and then plug it in again. If the problem continues contact an Authorised Service Centre.
•If the bowl symbol flashes on the screen and you cannot14 move onto the next step, this means that the motor