Tefal OB300160 Operation, Practical hints, Cleaning, (fig.1), (fig. 3 and 4), (fig. 7 and 8)

Notice OB SEB.qxp:Notice malin A6 10/01/08 9:34 Page 10

Description

1	- Removable lever	4	- Blade
2	- Hinged magnet	5	- Power supply cable storage
3	- Motor unit	6	- Power supply cable	GB
		7	- Serrated wheel

Operation

-Connect the appliance

-Takethe can opener by its handle.

-Lift the lever (fig.1) and raise the hinged magnet (fig. 2).

-Introduce the can in a slightly tilted position, bringing its edge on the serrated wheel

(fig. 3 and 4).

-Lower the lever and press gently, then flip down the magnet: the can will start to turn as soon as the knife enters and cutting will be performed automatically (fig. 5).

-The motor will stop automatically when the lid has been cut.

-Hold the can and raise the lever; the magnet will hold the cut lid (fig. 6).

Practical hints

-If there is an obstacle (bump, notch, weld or tab) on the edge of the can, start opening a little afterwards or open on the other end of the can. Some supposedly “stackable” cans can only be opened on one end (that is the broadest one).

-Aluminium can lids will not be held by the magnet.

-You must hold big food cans with the other hand during operation.

Cleaning

-Disconnect your appliance after use.

-Disassemble the lever by raising it to the maximum and then take it out of its recess by pulling it towards you (fig. 7 and 8)

-Wash the lever in hot soapy water, rinse it and leave to dry fully.

-Use a damp cloth to wipe the motor unit (do not immerse it) and clean the serrated wheel.

-To re-assemble the lever, replace it in its recess and lower it.

-You can stow the power supply cable in the recess provided.

10