Choice of plates

According to the model, you may use different sets

2

of plates.

1

 

• To remove the plates:

Hold the plates by the handles on each side and press the release button.

• To replace the plates:

Place the plate at an angle with the slots below the stops.

Press down on the plate to lock it down.

When using for the first time, wipe the plates using kitchen paper towel moistened with cooking oil.Remove the surplus cooking oil using clean kitchen paper towel.

Make sure that the appliance is not hot and unplugged before changing the plates.

Connection, switching on and pre-heating

Close the appliance.

Fully unroll the electrical cord.

Check that the electrical installation is compatible with the wattage and voltage stated on the bottom of the appliance.

Only plug the appliance into an earthed socket.

If it is necessary to use an electrical extension cord:

-it must have an earthed socket, and be suitably rated.

-take the necessary precautions to avoid people tripping over it.

If the power cord is damaged, it must be replaced by the manufacturer, their after sales service centre or a person with similar electrical qualifications in order to avoid any hazards.

Plug the electrical cord into the wall socket and switch on, the red light comes on.

When using for the first time, a slight odour or small amount of smoke may be given off; this is normal.

Leave the appliance to pre-heat: the green light comes on when the correct cooking temperature is reached. During cooking, it is normal for the green light to go on and off. Do not touch the hot surfaces of the appliance: use the handles.

English