Teka TR 735 AB manual Ceramic hobs with controls, Connecting the electricity, Positioning the oven

GB

Sealing joint

20/30 mm

Self-tapping screw for 20 and 30 mm thick worktops

Sealing joint

40 mm

fig. 3

20/30 mm

Self-tapping screw for 20 and 30 mm thick worktops

40 mm

fig. 4

The clips and the sealing joint are provi- ded, and can be found in the packaging.

Connecting the electricity

Before connecting the hob to the electric mains, check that the voltage and fre- quency of the mains matches what is shown on the hob’s rating plate, which is located lower down, and on the guarantee certificate or, where appropriate, the tech- nical datasheet supplied, which should be kept together with this manual.

The electric connection is made via an om- nipolar switch or plug where accessible, which is suitable for the intensity to be to- lerated and which has a minimum gap of 3

mmbetween its contacts, which will ensu- re disconnection in case of emergency or when cleaning the hob.

The connection should include correct ear- thing, in compliance with current norms.

If the flexible supply cable fitted to the VT CM hob model ever needs to be changed, it should be replaced by TEKA’s official service.

The input cable should not be in contact ei- ther with the body of the hob or with the body of the oven, if the oven is installed in the same unit.

Positioning the oven

See the corresponding manual.

The oven’s placement should be as shown in your instruction manual, and the manual should also be referred to when connec- ting the electricity. Before accessing the in- side of the appliance, the appliance should be disconnected from the power.

Ceramic hobs with controls

Joining the hob to the oven

or the control panel

For this purpose, four cardan telescopic shafts are included with the hob. (See fig.

5). The way to join them is as follows:

1Turn off the electricity.

2Detach the cardan telescopic shafts by pressing on the retention clip (A), where it says PUSH, with a slim screwdriver, and pull the extension out a few centi- metres.

3Remove the four pins from the ends (B).

4Put the oven part-way into its space, ta- king care not to drag the cardan teles- copic shafts coming from the hob, and leaving enough space to put in the other ends of the telescopic shafts into the shafts in the rear part of the control panel, and then replace the pins. (See fig. 5)

16