Connecting a PC or Macintosh
Connecting a PC or Macintosh to the Projector enables computer images for impressive presentations.
•The following display standards are supported by the HT211 (HT201 may not support some of
the higher resolutions): |
|
|
VGA 640x480 for graphics | VGA 640x400 for graphics | XGA 1024x768 |
VGA 640x350 for graphics | VGA 720x400 for text | Mac 1024X768 |
VGA 720x350 for text | SuperVGA 800x600 |
|
Macintosh at 640x480 | Macintosh at 832x624 |
|
•If your PC does not support XGA you will need to install a XGA graphics board. Consult your computer's owner's manual for your XGA configuration. If you need to install a new board, refer to the manual supplied with your new graphics board for installation instructions.
Notes
•Refer to the owner's manual supplied with your computer for more information about the computer video output
requirements and any special identification or configuring required by the projector image and monitor.
•Some Macintosh PowerBooks may need to set the mirroring to off to output 800x600 dot signals. Please consult your PowerBook manual or computer dealer for details.
Before connecting
•Turn off the components that are to be connected.
•The projector and computer will be turned on in "Using the Projector" on page 13. Do not turn on either the computer or unit until you read this section.
•Please also refer to the manual of the video component to be connected.
PowerBook Connection Depending on the model of your PowerBook, the additional Apple video cable adaptor may be required with the above connection.
10
