Connect the Portable Device
1.Connect the adapter plug into the power jack on the portable device. The voltage selection will be locked automatically and cannot be changed until the power output cord is disconnected from the device.
2.Turn on the portable device and use it as you would normally. While connected, myPower ALL Plus will power and charge your device. (As mentioned earlier, myPower ALL Plus will not charge a device if the voltage setting is lower than that required.)
or
Leave the portable device turned off and myPower ALL Plus will charge the device battery.
3.When finished, slide the Power switch to OFF to turn off the power when myPowerALL Plus is not in use.
NOTE: If your portable device displays a low voltage/low capacity or
TIP: For most portable devices, myPower ALL Plus can be used to power the device even when the device battery is not installed.
Connect the 5V Device
1.Connect the USB adapter tip (or other optional adapter tip
2.Connect the retractable USB cable into the USB port on myPower ALL Plus.
3.Connect the adapter tip into your 5V device.
4.Slide the Power switch to ON to turn on the power. While connected, myPower ALL Plus will power and charge your device.
5.Slide the Power switch to OFF to turn off the power when myPower ALL Plus is not in use.
NOTE: The USB port provides only 5V of power, so the voltage cannot be changed. When using this port, you will not select the voltage.
USER GUIDE | 11 |
