TDS 500D, TDS 600B & TDS 700D Performance Verification and Specifications 2–11

Nominal Traits

This section contains a collection of tables that list the various nominal traits

that describe the TDS 500D, TDS 600B, and TDS 700D oscilloscopes. Electrical

and mechanical traits are included.

Nominal traits are described using simple statements of fact such as “Four, all

identical” for the trait “Input Channels, Number of,” rather than in terms of

limits that are performance requirements.

Table 2–3: Nominal traits — Signal acquisition system

Name Description
Bandwidth Selections 20 MHz, 250 MHz, and FULL (No BW limit on TDS 794D)
Samplers, Number of TDS 540D, 580D, 644B, 684B, 754D, 784D, and 794D: Four, simultaneous
TDS 520D, 620B, 680B, and 724D: Two, simultaneous
Digitized Bits, Number of 8 bits1
Input Channels, Number of Four
Input Coupling DC, AC, or GND (TDS 794D – DC or GND only)
Input Impedance Selections 1 MWor 50 W(TDS 794D – 50 W only)
Ra
n
ges
,
O
ff
set
Alle e t D D
Volts/Div setting Offset range
(
All
e
xc
e
p
t
T
D
S 794
D
)1 mV/div – 100 mV/div
101 mV/div – 1 V/div
1.01 V/div – 10 V/div
±1 V
±10 V
±100 V
Ranges, Offset (TDS 794D only) 10 mV/div – 50 mV/div
50.5 mV/div – 99.5 mV/div
100 mV/div – 500 mV/div
500 mV/div – 1 V/div
±0.50 V
±0.25 V
±5 V
±2.5 V
Range, Position ±5 divisions
Range, 1 MW Sensitivity31 mV/div to 10 V/div2
Range, 50 W Sensitivity 1 mV/div to 1 V/div2 (10 mV/div – 1V/div on TDS 794D)
1Displayed vertically with 25 digitization levels (DLs) per division and 10.24 divisions dynamic range with zoom off. A DL
is the smallest voltage level change of the oscilloscope input that can be resolved by the 8-bit A-D Converter. Expressed
as a voltage, a DL is equal to 1/25 of a division times the volts/division setting.
2The sensitivity ranges from 1 mV/div to 10 V/div (for 1 M) or to 1 V/div (for 50 ) in a 1–2–5 sequence of coarse settings
with Fit-to-Screen off. Between coarse settings, the sensitivity can be finely adjusted with a resolution equal to 1% of the
more sensitive coarse setting. For example, between 50 mV/div and 100mV/div, the volts/division can be set with 0.5 mV
resolution.
31 M not available on TDS 794D