Tektronix TDS 600B, TDS 500D, TDS 700D - page 80

Performance Tests
1–64 TDS 500D, TDS 600B & TDS 700D Performance Verification and Specifications
HCHECK that the Ch2 High readout is ≥1.0 volt and that the Ch2
Low readout ≤0.25 volts.
HEnter high and low voltages on the test record.
Check output
Figure 1–21: Measurement of main trigger out limits
d. Check Delayed Trigger output against limits: See Figure 1–21.
HMove the precision 50 W cable from the rear-panel Main Trigger
Output BNC to the rear-panel Delayed Trigger Output BNC.
HCHECK that the Ch2 High readout is ≥1.0 volt and that the Ch2
Low readout ≤0.25 volts.
HEnter high and low voltages on test record.
HPress the side-menu button  to select the 1 MW setting. (This step
is not required on the TDS 794D – proceed to step 3.)
HPress CLEAR MENU.
HCHECK that the Ch2 High readout is ≥2.5 volts and that the Ch2
Low readout is ≤0.7 volts.
HEnter high and low voltages on test record.