Tektronix TDS 684A, TDS 744A, TDS 784A Appendix D: Factory Initialization Settings

TDS 684A, TDS 744A, & TDS 784A User Manual D–1
Appendix D: Factory Initialization Settings
Recalling the factory setup establishes the initialization settings shown in
Table D–1 to set the TDS Oscilloscope to a known default state.
Table D–1: Factory Initialization Defaults
Control Changed by Factory Init to
Acquire mode Sample
Acquire repetitive signal (TDS 700A models only) ON (Enable ET)
Acquire stop after RUN/STOP button only
Acquire # of averages 16
Acquire # of envelopes 10
Channel selection Channel 1 on, all others off
Cursor H Bar 1 position 10% of graticule height
(–3.2 divs from the center)
Cursor H Bar 2 position 90% of the graticule height
(+3.2 divs from the center)
Cursor V Bar 1 position 10% of the record length
Cursor V Bar 2 position 90% of the record length
Cursor amplitude units Base
Cursor function Off
Cursor mode Independent
Cursor time units Seconds
Date and time No change
Delayed edge trigger coupling Main Trigger
Delayed edge trigger level 0 V
Delayed edge trigger slope Rising
Delayed edge trigger source Channel 1
Delay trigger average # 16
Delay trigger envelope # 10
Delay events, triggerable after main 2
Delay time 16 ns
Delayed, delay by ... Delay by Time
Delayed, time base mode Delayed Runs After Main
Display clock No Change