Appendix C: Performance Verification

c.Select the file:

￿Push SETUP￿Waveform Sequence, if necessary, to select a waveform file for CH1. Waveform Sequence toggles between the CH1 files (upper list) and the CH2 files (lower list).

￿Turn the general purpose knob to highlight the MODE.WFM file.

￿Push ENTER to select the file.

3.Turn on the AWG2021 CH1 output: Push the CH1 button so that the LED above the CH1 output connector is on.

4.Check burst count: Push the AWG2021 MANUAL TRIGGER button and check that when the button is pushed, the oscilloscope displays three cycles of sine wave.

5.End procedure: Disconnect the oscilloscope.

Check Gated Mode

Electrical

￿pe￿a ing mode, Ga ed, on page#B$1.

Characteristic Checked

 

 

 

Equipment Required

Th￿ee 50#W coaxial cable￿, a 50 W p￿eci￿ion e￿mina ion, a

 

f!nc ion gene￿a o￿, and an o￿cillo￿cope.

 

 

Prerequisites

The AWG2021 mee ￿ he p￿e￿eq!i￿i e￿ li￿ ed on page C$5.

 

 

1.Install test hookup and set test equipment controls:

a.Hook up the oscilloscope: Connect the AWG2021 CH1 output connector through the coaxial cable to the CH1 vertical input connector on the oscilloscope.

b.Hook up the function generator: Connect the function generator output to both the AWG2021 TRIGGER INPUT and the oscilloscope CH2 input through a coaxial cable, precision termination, and a dual input coupler (see Figure C-6).

AWG2021 User Manual

C￿15