Installation

DNI-3 User Manual

7.Starting at the lowest DNI-3 panel and working upward, connect the DCS OUT cables to the NE-1 OUT termination points on the rear of the DNI-3 panels.

8.Secure the DCS OUT cables to the wire management tray via the tie-down slots.

9.Route the NE IN cables to the same side of the network bay as the DCS IN cables. Tie-wrap the cables in place within the extender panel cable management brackets.

10.Starting at the lowest DNI-3 panel and working upward, connect the NE IN cables to the NE-2 IN termination points on the rear of the DNI-3 panels.

11.Secure the NE IN cables to the tie-down bar.

12.Route the NE OUT cables to the same side of the network bay as the DCS OUT cables. Tie-wrap the cables in place within the ex- tender panel cable management brackets.

13.Starting at the lowest DNI-3 panel and working upward, connect the NE OUT cables to the NE-2 OUT termination points on the rear of the DNI-3 panels.

14.Secure the NE OUT cables to the tie-down bar.

IN

IN

Tie-Down

Bar

OUT

OUT

2-4

Telect, Inc.

108469

Issue A Rev 2