DNI-3 User Manual

Installation

INSPECTION

Compare the contents of the DNI-3 shipping container with the packing list. Call Telect if you are missing anything.

NOTE

Telect is not liable for shipping damage.

If the shipping container is damaged, keep it for the carrier’s inspection. Notify the carrier and call Telect’s Customer Service Department:

1-800-551-4567 or 1-509-926-6000

Keep the container until you have checked equipment operation. If you experience any kind of problem, call Telect’s Customer Service Department. Use the original, undamaged container if you are instructed to return the DNI-3 to Telect.

INSTALLATION PROCEDURE

Step Action

1.Align the DNI-3 chassis mounting holes with the mounting holes of the network bay.

2.Insert four 24 x 1/2" mounting screws (two on each side) into the mounting holes and securely tighten them.

3.Route the DCS IN cables to one side of the network bay. Tie-wrap the cables in place within the extender panel cable management brackets.

4.Starting at the lowest DNI-3 panel and working upward, connect the DCS IN cables to the NE-1 IN termination points on the rear of the DNI-3 panels.

5.Secure the DCS IN cables to the wire management tray via the tie- down slots.

6.Route the DCS OUT cables to the opposite side of the network bay. Tie-wrap the cables in place within the extender panel cable man- agement brackets.

Issue A Rev 2

108469

Telect, Inc.

2-3