Teledyne 2102 installation and operation guide Programming, Section Overview

2102 Wireless Communication Module

Section 4 Programming

4.1 Section Overview

This section describes how to set up the operation of a 2100 Parameter Module using Teledyne Teledyne Isco’s Flowlink for Windows software.

	Note
	The 2100 System requires Flowlink 4.1 or later. Earlier ver-
	sions do not support 2100 System instruments.
Flowlink Help	Detailed Flowlink instructions are beyond the scope of this
	manual. Flowlink’s operating instructions are available in a
	Windows Help format. You can access the help topics for an
	active window by clicking on its Help button or by pressing F1 on
	your computer’s keyboard. You can also access Help topics from a
	Contents and Index window (HELP>CONTENTS AND INDEX from
	the Flowlink menu).

4.2Flowlink Connections Make the necessary wiring connections to allow your computer to communicate with the site. Figure 4-1shows a connection using Teledyne Teledyne Isco’s Communication Cable, P/N 60-2004-046 (or 60-5314-849 for custom length).

There are two ways to connect to a site using a wireless base unit and Flowlink:

•Quick-Connect method - From the Quick-Connectdialog, select Wireless and then press the correct button to select the appropriate type of unit. Note that when using this connection method, you should select the button containing the type of equipment to which the remote is connected. A list of all the sites will appear. You have the option of selecting the site or entering the site name and connecting. You need to know only the site name when connecting to a remote.

•Open Existing Site method - Assuming the site already exists, you may simply open the site and connect or right-click on the site and connect. If a problem occurs, you should confirm that the Site Info tab has Wireless selected for the type of communication.

4-1