BATTERY INFORMATION

General

Improper battery selection, use, installation and care are the cause of numerous wireless system failures.

Alkaline Batteries: Alkaline batteries such as Mallory’s DURACELL or Eveready’s ENERGIZER provide the most reliable operation in wireless transceiv- ers. The use of low cost carbon-zinc batteries is NOT recommended.

Nickel-Cadmium Batteries: These batteries can save you money in the long run, as they can be recharged, but they can also cause disappointing wireless perfor- mance. If you want to use rechargeable nickel-cadmium batteries you must select a heavy duty nickel-cadmium (NEDA 10015 or equivalent)

BC-4 Battery Charger

BC-4 Battery Charger ￿Remove the battery holder from the TR-200.

Snap the terminal connector onto the battery holder and plug the charger into 110 Volt outlet.

Full charge of the battery pack is obtained after 14 to

16 hours. A full charge will last 8 to 10 hours. Exten- sive over-charging may damage or destroy the batter- ies. Please assure the charging time does not exceed

DURACELLÆENERGIZERÆ16 hoursisisaa.registeredtrademarkarkofDuracellUnionInc.Corporation.

Figure 13Carbide

CAUTION

DO NOT ATTEMPT TO CHARGE ANY A L K A L I N E BAT- TERIES WITH THIS C H A R G E R . T H I S CHAR G E R I S TO B E U S E D W I T H NICKEL CADMIUM BATTERIES USED IN THE TR200 BAT-

T E RY H O L D E R ONLY.

-13-

Page 15
Image 15
Telex tr-200p operating instructions Battery Information, General, BC-4 Battery Charger