Battery Recommendations

Fresh 9-volt alkaline batteries from a quality manufacturer will yield the best performance from your FMR-10 transmitters. Rechargeable 8.4-volt Ni-cad batteries can be used, but will yield much shorter op- erational time.

When the transmitter switch is turned on, the red battery light will flash once if the battery is good. If the light does not flash or stays lit continuously, the battery is weak or dead. If the light comes on during use, the battery is weakening and should be replaced as soon as possi- ble.

If sound quality degrades during use, it may be the result of a weaken- ing battery.

Receiver and Antenna Placement

Do not place the receiver near a large metal object or surface. Locate the receiver as close as possible to the area where the Trans- mitter user will be working. Ideally, position the receiver so that the transmitter is within site of the receiver.

When using multiple systems, do not allow antennas to cross or touch each other.

-18-

Page 20
Image 20
Telex WT-10, FMR-10 operating instructions Battery Recommendations, Receiver and Antenna Placement