Transmitter Setup
1.Open battery compartment, install 9 Volt battery. Make sure to observe proper battery polarity.
2.Adjust channel setting to match channel number shown on re- ceiver channel display. Replace battery cover.
3.If using bodypack transmitter, plug the microphone into the trans- mitter connector.
Operating the System
1.Turn transmitter ON via the ON/OFF switch. After a few sec- onds, the yellow “Tx On” light should illuminate on the receiver front panel.
2.Turn audio switch to the ON position to the audio.
3.Set mixer amp gain to normal position.
4.Talk/sing into the microphone at a normal volume. You should hear audio coming out of the system.
5.If the signal is distorted, turn the gain adjust control on the trans- mitter down. If the signal level is low, you may need to turn the gain adjust control up.
