![](/images/new-backgrounds/1259184/25918435x1.webp)
GE864 Hardware User Guide
1vv0300694 Rev.10 - 10/06/08
NOTE: don’t use any pull up resistor on the RESET# line nor any totem pole digital output. Using pull up resistor may bring to latch up problems on the
TIP: The unconditional hardware Restart should be always implemented on the boards and software should use it as an emergency exit procedure.
For example:
Let’s assume you need to drive the RESET# pad with a totem pole output of a +3/5 V microcontroller (uP_OUT2):
10k
This signal is internally pulled up so the pin can be left floating if not used.
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved | page 18 of 69 |