Battery Installation
Note:
The battery is an optional accessory that may or may not be available. Consult your service provider.
1.If necessary, remove the screw that may be holding the battery access door located on the bottom of the unit - see Figure 3.
2.Press the battery access door tabs and remove the battery access door.
3.Install the Telular rechargeable battery pack into the battery pack area and connect wires.
4.Reinstall the battery access door using the screw - see Figure 4.
|
|
| Battery Access Door |
| Battery Access |
|
|
|
| ||
| Door Tab And |
| |
| Screw |
| |
|
| Battery Pack Area | |
|
| ||
Figure 3 – Battery access door. |
| Figure 4 - Battery installation. | |
| ! | WARNING! |
| Do not use batteries other than the Telular battery pack included with the SX6P. | |
| Using any other batteries may result in fire and/or other damage to the unit. | |
|
|
|
Battery Operation
The SX6P will recharge its battery pack when connected to AC power. If AC power is interrupted, the SX6P will continue to operate, using power from the battery.
Location and Setup
The SX6P comes with a standard spike antenna (TNC – Terminal Node Controller).
1.Attach and
2.Select a location that is above ground and as close to windows (or exterior walls) as possible to get the best signal - see Figure 6.
Figure 5 - Attach the antenna. | Figure 6 - SX6P location. |
Phonecell® SX6P CDMA | 2 | User Manual |
