2-4 Installation
In Windows 95
Follow these steps if your computer is running Windows 95.
1. From the Taskbar, select Start then Shut Down.
2. Select the Restart the Computer in MS-DOS mode.
3. Click on Yes.
4. Type PHDISK /C /F at the DOS prompt and press Enter.
5. The DOS screen appears and shows the save file name and size. Press any
key to reset the system. The computer will reboot.
In Windows for Workgroups
Follow these steps if your computer is running MS-DOS and Windows for Workgroups.
1. Close all applications and exit Windows for Workgroups to MS-DOS.
2. At the command prompt (typically C:\) type PHDISK /C /F and press Enter.
This will create a file which can be used to save the contents of your memory
system when you perform a 0V Suspend operation.
2.3.3 Installing Advanced PCI Option Card
To install an Advanced PCI Card option, use the following procedure:
Caution: The Advanced PCI card option contains components that are
sensitive to static electricity. When handling the card and the internal
parts of the computer, protect against static electricity by using wrist or
ankle grounding straps and grounded working mats. When moving or
storing items, use the anti-static bags supplied with the items.
1. Ensure that the notebook is powered off and the AC adapter disconnected
from the AC outlet. Also, ensure that the battery is out of the unit.
2. Disconnect any peripheral device interface cables from the external interface
connectors and remove any installed PCMCIA options.
3. Turn the notebook over and locate the Advanced PCI Access Cover on the
bottom of the notebook (refer to Figure 2-2).
4. Remove the screw holding the Advanced PCI Access Cover and remove the
cover.
5. Review the installation instructions supplied with the Advanced PCI option
card.
6. Hold the card at the end opposite the connector pins with the label side up.
Insert the card firmly into the Advanced PCI connector on the Main Board.