Using The TPA005D12
3.4 Using The TPA005D12
The TPA005D12
The following paragraphs provide additional details for using the TPA005D12
3.4.1Installing and Removing EVM Boards
TI
Evaluation modules are easily removed from the platform by simply prying them up and lifting them out of their sockets. Care must be taken, however, to prevent bending the pins.
3.4.1.1EVM Insertion
1)Remove all power from the evaluation platform.
2)Locate sockets U2 and U3 on the platform.
3)Orient the module correctly.
4)Carefully align the pins of the module with the socket pin receptacles.
5)Gently press the module into place.
6)Check to be sure that all pins are seated properly and that none are bent over.
3.4.1.2EVM Removal
1)Remove all power from the evaluation platform.
2)Using an appropriate tool as a lever, gently pry up one side of the module a small amount.
3)Change to the opposite side of the module and use the tool to pry that side up a small amount.
4)Alternate between sides, prying the module up a little more each time to avoid bending the pins, until it comes loose from the socket.
5)Lift the EVM off of the platform.
Details