E12
CONNECTIONS
CONNECTINGPOWER
CAUTION:
CONNECTINGTO YOUR HEADPHONE
CONNECT YOURGUITARAND KEYBOARD
Youcanpower the system from a standard AC outlet by using the supplied power cord.
The suppliedAC power cord has a polarized plug that fits into the wall outlet only one way. If the plug
doesnot fit properly, turn it over and try again. Do not force it.
A headphone jack is provided for using headphones instead of the built-in speakers. (Headphones are sold
separately.)
1. Connect the guitar or keyboard to guitar input jack or keyboard input jack.
2. Press the POWER button to turn the unit on.
3. The sensitivity and loudness could be adjusted as required by turning the guitar or keyboard volume control
and/orthe master volume control.
PRIORTO CONNECTING
!
!
Alwaysturn off the Singing Machine, TV and other components before connecting or disconnecting any cables.
Please refer to the instructions below along with the instruction manual for the other component if connection
problemsoccur or more information is needed.
CONNECTING TO A VIDEO SYSTEM
CONNECTINGAVIDEO COMPONENT FOR OUTPUT
NOTE
COMMONWAYSTO CONFIGURE YOUR TV OR VCR
: Todisplay only the image on another video system, disconnect the
.The audio signal will originate from the built-in speakers on the unit.
Please use the provided CDG disc to test the connections. The lyrics and music of songs on the disc will be
displayedon the Singing Machine.
If you have never used the video input RCA jack or coaxial cable on your TV/VCR you should consult your
TV/VCR user guide. If you don’t have your manual, please contact your TV/VCR manufacturer for information
eitherby phone or by viewing their website for online assistance. They will be able to tell you very quickly how to
configureyour TV or VCR to display the video connection.
Thethree most common ways to set up the TV/VCR are:
1) A‘Video’ button may be on the TV/VCR or on the remote control. Pressing ‘Video’ may display the input from
yourSinging Machine.
2) Trylooking for a ‘Video’ channel between the regular channels on yourTV/VCR. Do this by setting the channel
onthe TV/VCR to channel 2 then pressing the ‘Down’ channel button to see if there is a ‘Video In’ or ‘Line In’
betweenthe lowest channel and the highest channel on your system.
3) The configuration may also be located in the set-up menu on the TV/VCR. Look for a section on ‘Input
Selection’where you might be able to choose the input source i.e.’Cable/Ant.’, ‘Video 1’, ‘Line In’or ‘Video In’.
Pleasefollow the steps below to share your Singing Machine display on another video system:
(1) Locatethe multicolor RCA patch cords.
(2) Connect yellow video cable to the Video Output jack, red audio cable to theAudio Right channel Output jack
andwhite audio cable to the Audio Left channel Output jack respectively on the back of the Singing Machine.
(3) Connect the other end of the cords to the Video Input jack,AUX Right/Left channel Input jacks on your video
systemrelatively.
Audio/AUX Right and Left channel
(Redand White) Output RCA cables
REAR VIEW OF
VIDEO SYSTEM
OUT
IN
LR
VIDEO
AV1
AUDIO
LR
VIDEO
AUDIO
AUXIN
L
R
VIDEO
IN
VIDEOOUT
(YellowJack)
AUDIOOUT
R
(RedJack)
AUDIOOUT
L
(WhiteJack)
VIDEOIN
(YellowJack)
AUXIN
R
(RedJack)
AUXIN
L
(WhiteJack)
REAR VIEW OF
SINGING MACHINE
ENGLISH