SECTION 5: UNPACKING, MOVING AND PLACING THE UNIT

FIGURE 6

FIGURE 7A

FIGURE 7B

 

 

 

 

TAPE

9.On all models, the bypass jet must be turned clockwise with a small flat-bladed screwdriver until fully seated to set proper low flow rate. See Figures 8 and 9.

FIGURE 8

FIGURE 9

10.All barbecue models are supplied with a pressure regulator that is packed with the unit. The regulator is set for natural gas. For use with propane, it must be converted. The regulator will be located on the left rear bottom of the unit. Using a flat blade

screwdriver, remove the cap on the top of the regulator and turn the cap over so that the letters LP are exposed. Make sure the spring in the regulator remains in position. Re-attach the cap to the regulator. See Figures 10 and 11, below.

Page 9