SECTION 4: ELECTRICAL REQUIREMENTS

AND GROUNDING INSTRUCTIONS

CAUTION

 

 

 

CAUTION

 

 

 

 

 

Installation of electrical supply circuit should be done by a qualified electrician in accordance with local codes and ordinances. In the absence of local codes or ordinances, the supply should be installed in accordance with the National Electric Code ANSI/NFPA No. 70, current issue, or Canadian Electric Code C22.1 Part 1.

The Thermador® Char Glo® barbecues use an electronic ignition system that requires a 120 VAC, 15A, 60 Hz power supply. A properly grounded duplex outlet must be provided adjacent to the lower left rear corner of the unit. See Figure 5A (below).

A properly grounded duplex outlet made for outdoor applications should also be provided above the level of the cooking surface on the left side of the unit. This outlet is required for connection of the rotisserie motor. See Figure 3 (Page 5).

WARNING

Electrical Grounding Instructions

This outdoor cooking gas appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug.

AVERTISSEMENT

Instruction pour la mise

a la terre electrique

Cet appareil est muni d’une fiche a trots broches (mise a la terre) afin de vous proteger des chocs et doit etre branche dire~ement dans une prise de courant a trots broches adequatement mise a la tem. II ne faut pas couper ou enlever la broche de mise a la tem de cette fiche.

Figure 5A

BARBECUE

Three-Prong Plug and Receptacle

Page 7