Winterizing Your Dishwasher
If your dishwasher will be unused for an extended period of time in a location that experiences freezing temperatures (e.g., in a holiday home or through a vacation period), have your dishwasher winterized by an authorized service center.
ATTENTION
To avoid dishwasher damage, do not allow water to remain in your dishwasher sys- tems through extended periods of freezing temperatures. Freezing temperatures can damage your dishwasher.
Wiping Up Spills and
Water may occasionally splash out of your dishwasher, especially if you interrupt a cycle or open the dishwasher door during a cycle. To avoid floor damage and possible mold growth, do not allow wet areas to remain around or under the dishwasher.
Check/Clean the Stainless Steel Inner Door and Tub
Clean the outer edges of the inside door panel regularly to remove debris that might collect there from normal loading.
If spots begin to appear on the stainless steel tub or inner door, make sure the rinse agent reservoir is full.
Check/Clean the Spray Arm Nozzles
Occasionally check the spray arms to ensure that the spray arm nozzles (holes) are unobstructed. You must remove the spray arms to check them for obstruction.
To remove the top spray arm:
1.Remove the empty top rack from the dishwasher.
2.Turn the rack
3.Remove the spray arm as shown in Figure 23.
4.Look for obstruction in the spray nozzles.
5.If the spray nozzles need cleaning, flush them under running water.
To reinstall the top spray arm:
1.Return the top spray arm to its installed position.
2.Return the locking nut to its installed position and turn it 1/8 turn clockwise.
3.Return the top rack to the top rack roller guides.
To remove the bottom spray arm:
1.Remove the empty bottom rack from the dishwasher tub.
2.Grasp and lift the bottom spray arm as shown in Figure 24.
3.Look for obstruction in the spray nozzles.
4.If the spray nozzles need cleaning, flush them under running water.
To reinstall the bottom spray arm:
1.Return the bottom spray arm to its installed position and press it so that it snaps into place.
2.Return the bottom rack to its installed position.
Figure 22
A
B
Figure 23
Figure 24
15
