OPERATION
The most effective method of removing vapours produced during cooking is to:
❑Switch the ventilator ON
as soon as you begin cooking.
❑Switch the ventilator OFF
a few minutes after you have finished cooking.
Display for fan setting |
|
|
|
| Fan | ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Light | Reduce fan | Fan ON and |
| speed | increase speed |
Fan OFF
Acoustic signal:
❑When a button is pressed, this is verified by an acoustic signal.
Switching off the acoustic signal:
❑Simultaneously press buttons 0 and + until a signal is emitted after approx. 3 seconds.
Switching on the acoustic signal:
❑Repeat the process.
Switching the fan ON
❑Press the + button or pull out the filter drawer.
Switching the fan OFF:
❑Press the 0 button.
The displayed { goes out shortly afterwards.
Or:
❑Keep pressing the – button until the fan switches off. The displayed { goes out shortly afterwards.
Intensive setting:
Maximum power is obtained at the intensive setting. It is only required for short intervals.
❑Keep pressing the + button until a ç appears in the display.
❑If the intensive setting is not cancelled by hand, the fan will automatically switch back to step } after 10 minutes.
Fan follow-on:
❑Press the ! button or push in the filter drawer.
The fan runs for 10 minutes at setting 1. At the same time a dot flashes in the display.
Then the fan switches off automatically.
Lighting:
❑Briefly press the a button to switch the light on and off.
❑The light can be switched on at any time, even though the fan is switched off.
❑Adjusting the brightness:
Hold down the a button until the desired brightness is obtained.
Switching on the light automatically, e.g. via a timer:
❑Fan and light must be switched off.
Setting the required fan speed:
❑Press the + button.
The fan speed is increased by one step.
❑Press the – button.
The fan speed is reduced by one step.
Switching on:
Simultaneously press the – and ! buttons.
❑After approx. 3 seconds the light switches on to acknowledge the setting.
Switching off:
Repeat the process with the light switched on.
❑After approx. 3 seconds the light switches off to acknowledge the setting.
PAGE 6
